• CH
Radio frequency and channel selection

 2020-9-27 Radio frequency and channel selection

Please use the frequency according to the requirements of the local radio regulatory authority. FRS, PMR, GMRS and other models have preset the receiving/transmitting frequency to this unit. You cannot modify the frequency, but you can modify the CTCSS and DCS code to eliminate the same frequency i......

Radio configuration instruction

 2020-9-27 Radio configuration instruction

The radio configuration is divided into factory standard configuration and dealer specified configuration. The standard configuration includes a battery, a belt clip, a strap, and a manual. Others: The charging base, adapter, and antenna are slightly different depending on the model and importi......

Analog amateur radio reset

 2020-9-27 Analog amateur radio reset

The amateur radio is equipped with a liquid crystal display and a numeric keypad, which is beautiful and generous and brings more convenient operation experience. Because you are unfamiliar with the radio set operation and wrong settings, you can use the RESET operation of the menu to restore th......

7. How to deal with the radios after entering the water?

 2020-9-27 7. How to deal with the radios after entering the water?

When using the radios, there may be accidents or other reasons that cause water enter to the radios. Correct rescue steps: The first step: unplug the battery immediately after the radio enters the water, shake the water out, and dry it in a ventilated and dry place. The second step: strive to be ......

6. No response when the radio is turned on?

 2020-9-27 6. No response when the radio is turned on?

What should do if the radios does not respond when turn it on? Don’t worry, confirm the following three points: 1> The battery power may be exhausted, please replace the battery or charge the battery; 2> The battery is not installed well, please remove the battery and re-install; 3> Poor b......

5. There are currently two ways to programming on the radios

 2020-9-27 5. There are currently two ways to programming on the radios

1> Computer programming. The common programming method of the radio. The frequency reading and writing operations are performed in the power-on state. First read the frequency to the radios, then edit the receiving and transmitting frequency or other functions, and finally write data to the radi......

4. What is the reason that the radios distance becomes shorter? How to solve it? 

 2020-9-27 4. What is the reason that the radios distance becomes shorter? How to solve it? 

Whether the antenna is tight or damaged. You can test with screwing or replacing the antenna. Whether the battery voltage is too low or the power is insufficient.

3. The radios have been used for a long time. How to solve the problem of shortened working hours? 

 2020-9-9 3. The radios have been used for a long time. How to solve the problem of shortened working hours? 

After using the radios for a period of time, it is normal for the battery's working life to shorten. Solution: In addition, add a spare battery or replace it with a new one (strongly recommend using the original factory battery)

2. Other sounds appear in the channel (crosstalk)

 2020-9-9 2. Other sounds appear in the channel (crosstalk)

When the radio has other noises during the conversation, how can it be resolved? Solution: It can be solved by modifying the frequency and sub-audio or changing the sub-audio settings. In this case, the entire group of radio needs to be reset.

1. LED indicator, the red light is always on, but it can be launched, how to solve it?

 2020-9-9 1. LED indicator, the red light is always on, but it can be launched, how to solve it?

Solution: The PTT button is broken or stuck; the head of the transmitting earphone is broken or short-circuited by water. Preventive treatment: Avoid using the equipment in a harsh environment for a long time.